Broadcast Microphone

RODE NTG-1 condenser directional microphone designed for professional field of film, video, television, dubbing and institutional

ARTICLE N° 26813
  • RODE NTG-1 Directional Microphone
  • Professional Sound Quality
  • Circuit with low noise level
  • Condenser Sensor
  • Solid metal construction
  • Reduced weight of about 105 g
  • Low handling noise
  • Supplied with clip and windshield in his pocket
  • Designed and manufactured in Australia
  • Guaranteed 2 years
  • Specifications
  • Acoustic Principle: Line gradient more
  • Polar Pattern: Super Cardioid
  • Frequency range: 20 Hz ~ 20,000 Hz high-pass filter at 80 Hz (12 dB / octave)
  • Output Impedance: 50 Ω
  • Signal / noise ratio (DIN / IEC 651): 76 dB (1 kHz rel 1 Pa to - IEC 651, IEC 268-15)
  • Equivalent Noise: 18 dB SPL (for IEC 651, IEC 268-15)
  • Maximum SPL: 139 dB (@ 1% THD at 1 kW)
  • Sensitivity at 1 kHz at 1 kW: -36 dB re 1Volt / Pascal (15 mV @ 94 dB SPL) +/- 2 dB (at 1 kHz in free field open circuit)
  • Dynamic Band - amp DIN / IEC 651: 121 dB (to IEC 651, IEC 268-15)
  • Power supply: Phantom P48, 44-52 V
  • Power consumption: 3.5 mA
  • Output connectors: 3-pin XLR, balanced output between pins 2 (+) 3 (-) and 1 (ground)
  • Average weight: 105 grams
Micro RODE NTG-1
Directional Condenser Microphone
The new RØDE NTG-1 is a lightweight condenser shotgun microphone, specifically designed for professional field of film, video, television, dubbing and institutional.
The NTG-1 provides an electronically balanced output level and operates under 48 V P48 standard.
Its bandwidth and directivity control coupled to the electronic SMT low noise and light weight, make it ideal NTG-1 to bind just a video camera (not supplied with accessories) or on a pole .
The NTG-1 comes with its clamp and a windscreen which removes the breath during outdoor recording under normal conditions.
Additional accessories are available for other applications.

Operation
The NTG-1 works with a standard 48V phantom power. He admits a voltage between 44 and 52 V positive polarity between terminals 2 and 3 via the output XLR connector.
Output Impedance
NTG-1 function in an optimum manner to a 1k Ohm load impedance. If a load below thereof is employed, the level of the output signal will be reduced.
The output of the NTG-1 is mirrored between pin 2 (hot) 3 (cold) and pin 1 (ground).
Directivity
 Supercardioid
Switchable Bass-Cut filter
 No

Spotlight on