Phoenix Audio - DRS-1
This product is no longer available for sale
These models in stock might interest you:
961,67 €
Warranty 3 years
Preamps
The Phoenix audio DRS-1 is a single-channel Class A microphone / DI preamp. Following the huge success of the preamp / DI DRS-2, 2-channel microphone, Phoenix Audio has launched the single-channel preamplifier / DI , 1/2 rack format. The Phoenix Audio DRS-1 uses the Class A (DSOP-2) output stage already present and appreciated on many models, but it also has the latest microphone input of Class A Discrete, transformerless, which gives a sound like "lamp". It also integrates the DI audio audio circuits, with high input impedance.
ARTICLE N° 57216
Specifications
-
Phoenix audio DRS-1 Single channel mono / DI mic preamp, in Class A.
-
Half rack, 1 unit and 240/110 volt power selector.
-
Class A output (DSOP-2).
-
Frequency response: 20Hz to 20kHz at +/- 0.5dB.
-
Maximum output level: + 26dBu at 1 kHz.
-
Signal noise: -90dB from 20Hz to 20 kHz.
-
Outputs connections: XLR and TRS Jack 1/4 inch at the back.
-
Class A Phoenix Audio Transformer.
-
Symmetrical microphone input level.
-
XLR microphone input on the front and back of the module.
-
Individual sockets switchable by button.
-
Mic Input Level: -30 to -70 in 5 dB steps with an additional 10 dB on the potentiometer.
-
Level of reduction: -30dB by push button micro / line (microphone input).
-
DI input with high impedance 1/4 "jack on the front.
-
Level meter by LEDs: green: 0dB, red: + 8dB corresponding to "4" and "6" on a VU-meter PPM.
-
Switchable phantom power by button.
-
Switchable High Pass Filter.
-
Switchable phase reverser.
-
Frequency response microphone input level: -0.4dB at 40Hz, -0.3dB at 25kHz.
-
Frequency Response Input Level DI: -0.3dB at 40Hz, 0.5dB at 25kHz.
-
Typical Headroom: + 24dB at micro pre-amplification level.
-
Volume level of the DI: 20dB maximum.
-
All units are equipped with military-grade PTFE silver cables.
Phoenix Audio - DRS-1
Phoenix Audio - DRS-1
961,67 €
Warranty 3 years