Lewitt - MTP 840 DM
Offers
Lowest price over 30 days
190 €
165 €
excl VAT
-13%
including eco-part : 0,14 €
In Stock
Usually ships within 3 days
+infos
Guarantee 3
years
Anais
Tristan
Do you need help?
Lewitt MTP 840 DM, supercardioid dynamic handheld microphone with clear sound and switchable active circuit.
ARTICLE N° 78262
Presentation
The Lewitt MTP 840 DM is a super-cardioid dynamic microphone with an active circuit (48v power supply required). When switched on, the active circuit boosts the microphone's sensitivity by 12 dB while preserving the original impedance. As a result, it can cut through any mix, even the densest!
What's more, its super-cardioid pick-up pattern reduces the risk of feedback, even at very high volumes.
The MTP 840 DM has been designed for vocals, but it also works very well on guitar amps, brass and woodwinds as well as toms.
The MTP 840 DM has a 3-position switch for changing its operating mode. You can choose between a passive mode and two active modes.
What's more, its super-cardioid pick-up pattern reduces the risk of feedback, even at very high volumes.
The MTP 840 DM has been designed for vocals, but it also works very well on guitar amps, brass and woodwinds as well as toms.
The MTP 840 DM has a 3-position switch for changing its operating mode. You can choose between a passive mode and two active modes.
Features
Capsule type
Dynamic
Application
Singing, Guitar / bass amplifier, Drum / percussions, Sax & brass, Live
Directivity
Supercardioid
Acoustic pressure (dB)
From 130 to 140
Switchable Bass-Cut filter
Yes
Switchable pad
Yes
Popfilter
Inside
Microphone clip
Yes
Power supply
Via +48 V phantom power supply
Frequency response, low limit
40 Hz
Frequency response, upper limit
18 kHz
Connectors
XLR male 3 pins
Packaging
Single unit
Other features
-
Lewitt MTP 840 DM
-
Hand-held vocal microphone
-
Type: dynamic moving coil
-
Acoustic operating principle: pressure gradient transducer
-
Switchable low-cut filter
-
Polar pattern: supercardioid
-
Frequency response: 40 - 18,000 Hz
-
Sensitivity: 3.5 mV/Pa, -49 dBV/Pa
-
Signal-to-noise ratio: 75 dB (A)
-
Equivalent noise level: 19 dB (A)
-
Dynamic range - Passive mode: 135 dB
-
Dynamic range - Active mode: 121 dB (0 dB gain), 115 dB (6 dB gain), 109 dB (12 dB gain)
-
Gain settings, active mode: 0dB, 6dB, 12dB
-
Linear low-frequency roll-off: 150 Hz (12 dB/octave), 250 Hz (12 dB/octave)
-
Internal impedance: 600 Ohm
-
Nominal load impedance: 1000 Ohm
-
Supply voltage: 48 V ± 4 V
-
Power consumption: 5.5 mA
-
Gold-plated 3-pin XLR connector
-
Dimensions: Ø 51 mm x 186 mm
-
Weight: 336 g
-
Supplied with microphone clip, windscreen and case
To find out more...
CAUTION :
When you choose passive mode, you must not supply phantom power. Doing so will cause serious damage to your microphone and will require repair (out of warranty).
When you choose passive mode, you must not supply phantom power. Doing so will cause serious damage to your microphone and will require repair (out of warranty).
Additional documents
You may also like
Spotlight on
Austrian manufacturer Lewitt, whose founders came up through the ranks at AKG, believes that good sound is for everyone, whether you're recording at home, on stage, or in the studio as a beginner or professional. To ensure that nothing limits your performance technically, Lewitt has advanced microphone technology by redesigning it from the ground up, such as the RAY studio condenser microphone, the LCT 140 AIR STEREO matched pair and the versatile LCT 440 PURE.
