EMG - 57 Bridge Black Chrome
105 €
excl VAT
including eco-part : 0,07 €
Out of stock
Contact us for delivery times
Guarantee 3
years
Guitar Microphone
The EMG 57 Bridge Black Chrome pickup revisits the PAF with fresh energy. The Alnico V gives grain and precision. There's zero hiss, even with a pushed amp. Everything is ready in the box: volume, tone, cabling, stereo jack and solderless assembly. Plug and play.
ARTICLE N° 108636
Presentation
Want a humbucker that doesn't saturate the soundstage? The EMG 57 Bridge Black Chrome pickup keeps things clean, even in dense terrain. It grows without swelling or blurring.
The Alnico V core retains the warmth of the PAFs, but with a very contemporary presence. Rendering is stable, even in low tuning. The centre frequency at 2.11 kHz adds real depth to the mix.
This pickup is bridge-mounted, with 49 mm Tune-O-Matic spacing. Installation is straightforward thanks to the EMG solderless system. No ground cable, no headaches!
You get everything in the pack: cables, stereo jack, 25k potentiometers, connection bus. It runs for over 1500 hours on a 9V battery, with minimal power consumption.
The black chrome look works on stage and in the studio. Just a mic ready to do the job, cleanly, without noise or signal loss.
The Alnico V core retains the warmth of the PAFs, but with a very contemporary presence. Rendering is stable, even in low tuning. The centre frequency at 2.11 kHz adds real depth to the mix.
This pickup is bridge-mounted, with 49 mm Tune-O-Matic spacing. Installation is straightforward thanks to the EMG solderless system. No ground cable, no headaches!
You get everything in the pack: cables, stereo jack, 25k potentiometers, connection bus. It runs for over 1500 hours on a 9V battery, with minimal power consumption.
The black chrome look works on stage and in the studio. Just a mic ready to do the job, cleanly, without noise or signal loss.
Other features
-
EMG 57 Bridge Black Chrome
-
Type : 6-string active humbucker
-
EMG 57 series
-
Position : Bridge
-
.
-
Voicing : Inspired by PAF humbuckers
-
Magnet : Alnico V
-
Coils: Steel poles
-
Tone: Warm, precise, very defined
-
Output level (string): 3.00 V
-
Output level (strumming): 4.50 V
-
Resonance frequency: 2.11 kHz
-
Output impedance: 10 kΩ
-
Noise floor: -100 dBV at 60 Hz
-
Maximum supply voltage: 27 V
-
Current consumption: 160 µA (overall)
-
9V battery life: 1500 hours
-
Installation: Solderless system included
-
EMG accessory compatibility: Yes (VLPF, EXG, SPC, RPC)
-
Standard spacing (Tune-O-Matic) 49mm
-
Short shaft potentiometer (Strat) 10 mm
-
.
-
1 volume potentiometer 25k
-
1 25k tone potentiometer
-
1 drum bus
-
1 stereo output jack
-
1 in/out bus for two microphones
-
1 microphone cable (38 cm)
-
1 output cable (15 cm)
-
2 connector cables (14 cm)
-
1 battery cable (18 cm)
-
1 pair of screws and springs
-
.
-
Length: 78.5 mm
-
Width: 38.1 mm
-
Height: 22.8 mm
-
Screw centre distance: 69.8 mm
