Guitar Microphone

The Floyd Axe long Black Chrome 57TW pickup puts two grains under your fingers. Nervous single mode, loaded humbucker, calibrated voltages, push/pull without delay and what's more with hybrid alnico and steel magnets! It includes a long shaft potentiometer designed for Les Pauls. It's easy to assemble thanks to its solderless wiring.

ARTICLE N° 107960
The EMG 57TW Floyd long-axis chrome pickup packs two voices into one shell. Its triple active coil generates a solid double mode and a sharper single. Push/pull provides access to both, without latency or voltage loss.

Designed for Floyd Rose-style vibrato guitars, it has a 52 mm spacing. Its 28 mm height means it can be mounted directly onto a hollow or solid body. The long shaft potentiometer can be fitted to a thick top.

Output voltage follows the mode: 3.00 V dual, 2.00 V single. Noise level remains low, even at full power. Power consumption never exceeds 160 μA.

Installation is based on the solderless EMG system. Every cable is supplied: battery, signal, TW pickup, B245 bus. A stereo jack plug, two tone controls and battery foam complete the kit. The 57TW Floyd combines strength, nuance and modularity.
  • EMG 57TW Floyd Long axle Black Chrome
  • Series: EMG TW Series
  • Type : Dual mode microphone (humbucker / single coil)
  • Triple-coil active pickup
  • Trem spacing (Floyd/Fender) 52 mm
  • Long shaft potentiometer (Les Paul) 19 mm
  • Humbucker/single-coil selection via push-pull
  • Magnets : Alnico + steel (hybrid)
  • Single resonance frequency: 3.47 kHz
  • Double resonance frequency: 1.77 kHz
  • String output voltage: 2.00V (single)
  • String output voltage: 3.00V (double)
  • Strum output voltage: 3.00V (single)
  • Strum output voltage : 4.50V (double)
  • Output impedance : 10 kΩ
  • Noise floor : -107 dBV (60 Hz)
  • Power consumption: 160 μA at 9V
  • Maximum power supply: 27V DC
  • 9V battery life: approx. 1500 hours
  • Active humbucker format
  • Thickness: 28 mm (1.1")
  • Standard EMG height: 23 mm (0.9")
  • Direct mounting or with springs supplied
  • Integrated single/double coil switching
  • Volume master
  • Volume pickup
  • Tone master
  • Tone pickup
  • Terminals H1 to H6
  • Solderless assembly possible
  • 1 Push-Pull potentiometer 25K (volume/tone)
  • 1 output cable (15 cm)
  • 2 connector cables (14 cm)
  • 1 battery cable (18 cm)
  • 1 TW pickup cable (38 cm)
  • 1 B245 Pickup Buss
  • 2 passive tone controls (25K)
  • Stereo output jack
  • Foam for 9V battery
  • Mounting springs and screws
  • Full manual with wiring diagrams
  • Length: 78.5 mm
  • Height: 28 mm
  • Depth: 38.1 mm
  • Approximate weight: 390 g (with pot and wiring)
The voicing of the EMG 57TW guitar pickup is better matched to a through-body. Sustain gains in thickness, especially in humbucker mode. The triple winding offers a unique dynamic response, rarely found elsewhere.

A handmade overdrive with broken grain rounds it off magnificently. Even direct to the PA, it retains its character. Every attack remains legible, even without a dedicated amp. The push-pull then becomes an instant expression tool.

This pickup handles dirty textures well without drowning. With a forgotten vintage transistor amp, the result is still very inspiring. It colours little, but never remains neutral.
EMG - 57TW Floyd Long Shaft Black Chrome
EMG - 57TW Floyd Long Shaft Black Chrome
120,83 € excl VAT
including eco-part : 0,07 €
Out of stock
Contact us for delivery times
Guarantee 3  years
Fred
Fred
Eric
Eric
Do you need help?

Spotlight on