EMG - 60A Chrome
90 €
excl VAT
including eco-part : 0,07 €
Out of stock
Contact us for delivery times
Guarantee 3
years
Fred
Eric
Do you need help?
Guitar Microphone
The EMG 60A Chrome pickup is soft without losing its attack. The Alnico magnet smoothes out the edges, while maintaining clarity. With neck or bridge, it delivers a precise, dense signal. It's a pickup that's at home with blues and controlled saturation.
ARTICLE N° 108088
Presentation
The EMG 60A Chrome is a microphone for those who want a nuanced sound. Its Alnico magnet gives mellow high frequencies without masking the attack. The audio remains direct and never aggressive.
The signal remains clear, even with a heavy draw. The midrange comes through naturally, perfect for rhythm or bluesy lines. In solo mode, it delivers a good hold in the bends.
The pickup accepts voltages from 9 to 27 volts. So you can push it or tone it down depending on how you want it to sound. Its output remains constant, even when playing hard.
Installation takes very little time. The solderless EMG system works well and limits errors. Cabling is supplied, with everything you need.
Visually, chrome imposes a real personality. A brilliant touch in a sober or vintage setup. The 60A stands out as a good choice for those who like to sculpt their grain without forcing the amp.
The signal remains clear, even with a heavy draw. The midrange comes through naturally, perfect for rhythm or bluesy lines. In solo mode, it delivers a good hold in the bends.
The pickup accepts voltages from 9 to 27 volts. So you can push it or tone it down depending on how you want it to sound. Its output remains constant, even when playing hard.
Installation takes very little time. The solderless EMG system works well and limits errors. Cabling is supplied, with everything you need.
Visually, chrome imposes a real personality. A brilliant touch in a sober or vintage setup. The 60A stands out as a good choice for those who like to sculpt their grain without forcing the amp.
Other features
-
EMG 60A Chrome
-
Type: Micro double coil (humbucker)
-
Series: EMG Active Series
-
Alnico magnet for softened sound
-
Tighter coils than the EMG 85
-
Powerful output with accentuated midrange
-
Balanced highs, smooth, clear sound
-
Good for blues or crunch sounds
-
Designed for neck or bridge position
-
Frequency response: 1.80 kHz
-
Output voltage (string): 3.00 V
-
Output voltage (strummed): 4.50 V
-
Noise level (60 Hz) : -100 dB
-
Output impedance: 10 kΩ
-
Standard spacing (Tune-O-Matic) 49mm
-
Potentiometer short shaft (Strat) 10 mm
-
Power consumption: 400 µA at 9 V
-
Battery life: approx. 600 hours
-
Maximum supported voltage: 27 V
-
1 25k volume potentiometer
-
1 25k tone potentiometer
-
1 battery bus
-
1 stereo output jack
-
1 in/out bus for two microphones
-
1 microphone cable
-
2 connector cables
-
1 output cable
-
1 pair of mounting screws and springs
-
EMG solderless installation system
-
Length: 69.8 mm
-
Height: 38.1 mm
-
Width: 22.8 mm
-
Weight: approx. 78.5 g
To find out more...
The EMG 60A Chrome pickup integrates well into an HX Stomp setup. Textures remain defined, even with complex or stacked effects.
In an SG, the midrange gains body without excess. The tonal balance remains evenly distributed throughout the mix.
The volume pot modulates without compromising overall colour. The transition from clean to crunch retains its natural coherence.
The alnico softens the attacks without shortening the sustain. Every note breathes, especially on expressive levels.
In an SG, the midrange gains body without excess. The tonal balance remains evenly distributed throughout the mix.
The volume pot modulates without compromising overall colour. The transition from clean to crunch retains its natural coherence.
The alnico softens the attacks without shortening the sustain. Every note breathes, especially on expressive levels.
