EMG - 60AX Chrome
97,50 €
excl VAT
including eco-part : 0,07 €
Out of stock
Contact us for delivery times
Guarantee 3
years
Fred
Eric
Do you need help?
Guitar Microphone
The EMG 60AX Chrome microphone combines power and naturalness. Thanks to its Alnico magnet and X Series preamp, it projects a smooth, articulate sound. Its dynamics remain solid when strummed. With no soldering, assembly is child's play.
ARTICLE N° 108101
Presentation
The EMG 60AX Chrome pickup is all about clarity and nuance. Its Alnico magnet provides a softer attack, with no loss of definition. The tone remains full-bodied, even at low volume.
With the X Series preamp, you benefit from a wider dynamic range. It pushes up to 8 volts on heavy strumming. Every nuance comes through, even on complex strings.
Solderless assembly simplifies installation. All the necessary cables are included, including the Pickup Buss. You save time without touching the soldering iron.
This model works with all other active EMG microphones. It integrates seamlessly into an 81X or 85X set for a complete configuration. Its standard format and colour match all guitars.
Looking for a neck pickup that reacts like an active pickup, but sounds almost like a passive one? The 60AX bridges the gap between the two worlds.
With the X Series preamp, you benefit from a wider dynamic range. It pushes up to 8 volts on heavy strumming. Every nuance comes through, even on complex strings.
Solderless assembly simplifies installation. All the necessary cables are included, including the Pickup Buss. You save time without touching the soldering iron.
This model works with all other active EMG microphones. It integrates seamlessly into an 81X or 85X set for a complete configuration. Its standard format and colour match all guitars.
Looking for a neck pickup that reacts like an active pickup, but sounds almost like a passive one? The 60AX bridges the gap between the two worlds.
Other features
-
EMG 60AX Chrome
-
Dual-coil guitar pickup
-
Series: EMG Active X Series
-
Magnet : Alnico
-
Resonance frequency: 1.84 kHz
-
Output voltage (string): 3.00 V
-
Output voltage (scratched): 8.00 V
-
Background noise: -105 dB
-
Compatible with all active EMG microphones
-
Solderless installation thanks to connector cables
-
Operates on one 9V battery (not supplied)
-
Battery life: 3000 h
-
Power consumption: 80 µA at 9V
-
Output impedance: 2.00 kΩ
-
Max. supply voltage: 27V DC
-
No string ground required
-
Standard spacing (Tune-O-Matic) 49mm
-
Short shaft potentiometer (Strat) 10 mm
-
1 x Mic cable: 38 cm
-
1 x Output cable: 15 cm
-
2 x Connector cables: 14 cm
-
1 x Battery cable: 18 cm
-
1 x Power cable: 14 cm
-
1 x Active volume potentiometer (25K)
-
1 x Active VLPF tone control
-
1 x 12B stereo jack (output)
-
1 x Insulating foams for battery
-
1 x Screw kit (screws + springs)
-
1 x Pickup Buss distribution box (for 2 microphones)
-
Length: 69.8 mm
-
Height: 22.8 mm
-
Width: 38.1 mm
To find out more...
The Alnico magnet in this model modulates the inductance and promotes a broader attack. This configuration makes the midrange more present, without going overboard.
At 38 cm, the voltage drop is negligible. The signal retains its dynamic range, even with long cables.
At reduced voltage, the 60AX remains stable, but its attack softens slightly. The preamp resists overheating well, and of course without any perceptible drift.
At 38 cm, the voltage drop is negligible. The signal retains its dynamic range, even with long cables.
At reduced voltage, the 60AX remains stable, but its attack softens slightly. The preamp resists overheating well, and of course without any perceptible drift.
