EMG - H1 Bridge Black Chrome
90 €
excl VAT
including eco-part : 0,07 €
Out of stock
Contact us for delivery times
Guarantee 3
years
Fred
Eric
Do you need help?
Guitar Microphone
The EMG H1 Bridge Black Chrome is a vintage humbucker that's dust-free. It slams in the midrange and opens up nicely in the clean. Ceramic/steel magnets for punch without aggression. No parasitic noise and quick assembly. It's perfect for a rock or garage guitar, especially with good 500k cabling.
ARTICLE N° 108496
Presentation
The EMG H1 Bridge Black Chrome ticks all the boxes if you want a passive humbucker that pushes without jamming. It combines punch, clarity and fuss-free editing. No need for batteries. Everything runs through standard passive cabling.
The over-wound coils deliver a dry, direct crunch. The attack comes out well, without excessive highs. The spectrum remains broad thanks to the ceramic/steel combo. This is a pickup made for 60s rock or fat garage riffs.
It comes with everything you need: 500k pots, mono jack, cables, screws, springs, connectors, bridge ground. Solderless wiring makes everything simple, even when you're setting it up for the first time. You save time and avoid mistakes.
This model retains the EMG markings while keeping a passive base. Impedance is 74 kOhm at resonance. It stays in tune even at low volume. And at 160 grams, it doesn't weigh anything down. Just the sound.
The over-wound coils deliver a dry, direct crunch. The attack comes out well, without excessive highs. The spectrum remains broad thanks to the ceramic/steel combo. This is a pickup made for 60s rock or fat garage riffs.
It comes with everything you need: 500k pots, mono jack, cables, screws, springs, connectors, bridge ground. Solderless wiring makes everything simple, even when you're setting it up for the first time. You save time and avoid mistakes.
This model retains the EMG markings while keeping a passive base. Impedance is 74 kOhm at resonance. It stays in tune even at low volume. And at 160 grams, it doesn't weigh anything down. Just the sound.
Other features
-
EMG H1 Bridge Black Chrome
-
Type : Passive humbucker microphone
-
Series : EMG-HZ
-
.
-
High-efficiency passive pickup
-
Overwound coils for extra punch
-
Ceramic/steel magnets (type C/S)
-
Clear, open sound in neck position
-
Defined crunch sound in bridge position
-
Perfect for 60's / 70's rock sounds
-
Simple solderless assembly
-
Solderless EMG connection included
-
No 9V power supply required
-
Red wire = coil, not power supply
-
DC resistance: 13.65 kOhm (H1)
-
Inductance: 7.15 H (H1)
-
Resonance frequency (1 MΩ): 3.12 kHz
-
Resonance frequency (500k + 6m cable): 1.65 kHz
-
Resonance impedance: 74 kOhm
-
Compatible with VLPF, EXG, etc circuits
-
5-wire connections: green, white, red, black, shielded
-
Mono output, with bridge earthing
-
Standard spacing (Tune-O-Matic) 49mm
-
Potentiometer short shaft (Strat) 10 mm
-
.
-
1 volume potentiometer 500k
-
1 500k tone potentiometer
-
1 mono output jack
-
1 bus in/out for 2 microphones
-
1 pair of screws + springs
-
1 microphone cable (38 cm)
-
2 connection cables (14 cm)
-
1 output cable (15 cm)
-
1 bridge ground cable (15 cm)
-
1 IDC connector for bridge ground
-
.
-
Length: 78.5 mm
-
Width: 38.1 mm
-
Height: 22.8 mm
-
Approximate weight: 160 g
To find out more...
The EMG H1 Bridge Black Chrome comes out in style. Its clarity remains sharp, even at drop C. The long cable lengths pull the treble down slightly, adding fatness. With a well-set treble-ble, every drop in volume retains its brilliance. Riff or arpeggio, everything stays crisp and catchy.
