Neumann - MA 1
224,17 €
excl VAT
In Stock
Usually shipped within 3 days
+infos
Warranty 3 years
Jessie
Louis
Need help ?
Measurement Microphone
KH DSP Automatic Monitor Alignment System for Speakers/Subwoofers with Calibration Software and Measurement Microphone - Mac/PC
ARTICLE N° 75843
Specifications
-
Neumann MA 1
-
Calibration microphone
-
Requires 48V phantom power supply
-
Multichannel expansion possible - automatic referencing for Quad, 5.1, 7.1, 5.1.4 and 7.1.4 multichannel systems with network-compatible speakers (KH 80, KH 120 II, KH 150 and KH 750) plus up to 4 subwoofers via an optional separate license not supplied
-
Technical specifications:
-
Acoustic operating principle: Pressure transducer
-
Directional pattern: Omnidirectional
-
Frequency range: 20 Hz - 20 kHz
-
Sensitivity at 1 kHz in 1 kohm: 30 mV/Pa -30 dBv +/- 3 dB uncalibrated | 30 mV/Pa -30 dBv +/- 0.5 dB calibrated (via software)
-
Nominal impedance: 50 ohms
-
Nominal load impedance: 1000 ohms
-
Equivalent noise level, CCIR: 39 dB
-
Equivalent noise level, A-weighted: 27 Db-A
-
Maximum SPL for THD 0.5: 132 dB
-
Signal-to-noise ratio, CCIR (re. 94 dB SPL): 55 dB
-
Signal-to-noise ratio, A-weighted (re. 94 dB SPL): 67 dB
-
Maximum output voltage: 10 dBu
-
Supply voltage (P48, IEC 61938): 48V +/- 4V
-
Power consumption (P48, IEC 61938): 3 mA
-
Corresponding connector: XLR3F
-
Weight: 37g
-
Diameter: 23 mm
-
Length: 117 mm
-
Minimum system requirements:
-
• Windows 10 (64 Bit)+
-
• macOS 10.15+
-
• CPU min.: AMD Multicore, Apple Silicon, Intel Core
-
• Display: 1280 x 720
-
• Internet connection for download / installation / activation
-
• Digital audio interface with microphone input + 48V phantom power and 2 outputs minimumo
-
• Network switch min. 3 ports
-
What's in the box:
-
1 x MA 1 Microphone
-
1 microphone clip
-
1 x Quick Guide
-
1 x Safety Guide
-
Software is available for download
Presentation
Allows you to optimize monitors with minimal effort
The MA 1 is a Level A optimization tool for a stereo set of Neumann KH Series DSP monitors.
It is also compatible with KH 750 DSP subwoofer installations.
This powerful automatic monitor alignment system is easy to use. Simply connect your speakers to the balanced analog outputs of your audio interface - you can also connect them to the balanced analog outputs of a monitor controller. If your interface has an AES3 port, you can also connect your KH 750 DSP subwoofer to it. Your DSP-powered monitors or subwoofer should also be connected to the Ethernet port of your computer (use a standard Ethernet switch for multiple connections). Next, you should connect the supplied measurement microphone to the microphone input of your audio interface (phantom power of +48V is required). Finally, run Fraunhofer’s proprietary calibration software and algorithms to optimize the frequency curve of your DSP-powered monitors, as well as the amplitude and phase response of all the speakers in your setup. Best of all, your calibration data is stored right inside your DSP monitors. This means you won’t accidentally leave a plug-in instanced on your mix bus while rendering—a common frustration with many software room correction solutions. Plus, your alignment settings will remain consistent across all of your sessions, even if they use different applications.
The MA 1 is a Level A optimization tool for a stereo set of Neumann KH Series DSP monitors.
It is also compatible with KH 750 DSP subwoofer installations.
This powerful automatic monitor alignment system is easy to use. Simply connect your speakers to the balanced analog outputs of your audio interface - you can also connect them to the balanced analog outputs of a monitor controller. If your interface has an AES3 port, you can also connect your KH 750 DSP subwoofer to it. Your DSP-powered monitors or subwoofer should also be connected to the Ethernet port of your computer (use a standard Ethernet switch for multiple connections). Next, you should connect the supplied measurement microphone to the microphone input of your audio interface (phantom power of +48V is required). Finally, run Fraunhofer’s proprietary calibration software and algorithms to optimize the frequency curve of your DSP-powered monitors, as well as the amplitude and phase response of all the speakers in your setup. Best of all, your calibration data is stored right inside your DSP monitors. This means you won’t accidentally leave a plug-in instanced on your mix bus while rendering—a common frustration with many software room correction solutions. Plus, your alignment settings will remain consistent across all of your sessions, even if they use different applications.
Information
Connectors
XLR male 3 pins
Frequency response
20 Hz - 20 kHz
Frequency response, upper limit
20 kHz
Frequency response, low limit
20 Hz
Neumann - MA 1
Neumann - MA 1
224,17 €
excl VAT
In Stock
Usually shipped within 3 days
+infos
Warranty 3 years
Jessie
Louis
Need help ?
Spotlight on
A legendary brand for decades, present in all the major recording studios, Neumann is a guarantee of high quality and professionalism. The Beatles, Natalie Cole, Celine Dion, Bryan Adams and Beyoncé... all use this exceptional brand with the famous U87, and the TLM49 at the top of the list. In home studio, the TLM103 and TLM102 condenser microphones are the most popular. For studio sound on stage opt for the KMS105. In recent years, Neumann has also offered the high-end KH80, KH120 and KH310 monitors.
Similar Products
Tops of the brand
