EMG - H1 Neck Black
75 €
excl VAT
including eco-part : 0,07 €
Out of stock
Guarantee 3
years
Fred
Eric
Do you need help?
With the EMG H1 Neck Black pickup, the audio remains natural and without excess. The over-wound coils add bite for clean playing. There's no complex wiring: the assembly is solderless. It's a passive humbucker with ceramic/steel magnets designed for those who want raw, unfiltered rock.
ARTICLE N° 108541
Presentation
If you're looking for a neck humbucker that breathes, EMG's H1 Neck is the answer. It retains dynamics even when played softly. Its attack remains lively, without overpowering the guitar's original grain.
The C/S magnets and reinforced coils add body. The pick-up retains a good degree of openness, with a balanced spectrum. You don't need to play loud to get a direct response.
No batteries or soldering required. Cables, connectors, pots: everything is supplied for a clean installation. The 5-wire cabling allows a wide range of possibilities depending on your configuration.
Designed for passive configurations, it fits naturally into a standard guitar. It's still compatible with EMG active modules, for those who want to go even further.
Weighing just 160 grams and with compact dimensions, it requires no adjustment. It's a great buy if you want to rediscover the sound of garage or psychedelic riffs.
The C/S magnets and reinforced coils add body. The pick-up retains a good degree of openness, with a balanced spectrum. You don't need to play loud to get a direct response.
No batteries or soldering required. Cables, connectors, pots: everything is supplied for a clean installation. The 5-wire cabling allows a wide range of possibilities depending on your configuration.
Designed for passive configurations, it fits naturally into a standard guitar. It's still compatible with EMG active modules, for those who want to go even further.
Weighing just 160 grams and with compact dimensions, it requires no adjustment. It's a great buy if you want to rediscover the sound of garage or psychedelic riffs.
Other features
-
EMG H1 Neck Black
-
Type: Passive humbucking microphone
-
Series : EMG-HZ
-
.
-
High-efficiency passive microphone
-
Overwound coils for extra punch
-
Ceramic/steel magnets (type C/S)
-
Clear, open sound in neck position
-
Perfect for 60's / 70's rock sounds
-
Simple solderless assembly
-
Solderless EMG connection included
-
No 9V power supply required
-
Red wire = winding, not power supply
-
DC resistance: 13.65 kOhm (H1)
-
Inductance: 7.15 H (H1)
-
Resonance frequency (1 MΩ): 3.12 kHz
-
Resonance frequency (500k + 6m cable): 1.65 kHz
-
Resonance impedance: 74 kOhm
-
Compatible with VLPF, EXG, etc circuits
-
5-wire connections: green, white, red, black, shielded
-
Mono output, with bridge earthing
-
Standard spacing (Tune-O-Matic) 49mm
-
Potentiometer short shaft (Strat) 10 mm
-
.
-
1 volume potentiometer 500k
-
1 500k tone potentiometer
-
1 mono output jack
-
1 bus in/out for 2 microphones
-
1 pair of screws + springs
-
1 microphone cable (38 cm)
-
2 connection cables (14 cm)
-
1 output cable (15 cm)
-
1 bridge ground cable (15 cm)
-
1 IDC connector for bridge ground
-
.
-
Length: 78.5 mm
-
Width: 38.1 mm
-
Height: 22.8 mm
-
Approximate weight: 160 g
Additional documents
You may also like
Spotlight on
With EMG,
customize your instrument with the best guitar pickups. EMG, the reference in
terms of sound and precision.
