Guitar Microphone

Designed for modern guitars, this duo of EMG 57/66 TW Axe Long Black pickups adapts to all registers. Built-in push-pull to switch between two distinct grains. Alnico or ceramic magnets, depending on position! The set includes everything you need to install it without a soldering iron.

ARTICLE N° 107920
The EMG 57/66 TW Axe Long Black pickup set offers two voices per pickup. One is a clear, single-coil mode, the other more massive. Changeover is by push-pull, without the need for an additional switch. The bridge pickup uses alnico and steel magnets. Its sound is dry, precise and sharp.

As for the neck, the 66TW combines alnico and ceramic. The result is fluid, with no excess or loss of definition. The EMG hybrid design works in three coils. Every detail of the timbre is under control, with no hiss or burrs.

This model is designed for guitars with a Floyd-type bridge (52 mm spacing). The long potentiometer (19 mm) is designed for thick-top models like the Les Paul. All cables are supplied, with solderless connections.

One 9V battery is enough to power the whole thing for over 1,500 hours. The signal remains powerful, even during intense rhythm playing. This duo can be used with all EMG configurations, solo or as a complement.
  • EMG 57/66 TW Set Long Axle Black
  • EMG TW Series
  • Dual mode pickups: humbucker and single coil
  • Potentiometer axis length: (Les Paul) 19 mm
  • Integrated Push-Pull selection system
  • 57TW (bridge): alnico + steel magnets
  • Clear, powerful sound with single coil
  • Warm, aggressive sound in double winding
  • 66TW (neck): ceramic + alnico magnets
  • Fluid, precise and expressive timbre
  • Exclusive EMG three-coil hybrid design
  • Compatible with all EMG pickups
  • Solderless installation via included connectors
  • 25K potentiometers for active pickups
  • Trem spacing (Floyd/Fender) 52 mm
  • Long shaft potentiometer (Les Paul) 19 mm
  • No bridge ground required
  • Requires one 9V battery (not included)
  • Battery life: approx. 1500 hours
  • High output level and very low noise
  • Resonance frequency: 3.47 kHz (single)
  • Resonance frequency: 1.77 kHz (double)
  • Output impedance: 10 kΩ
  • Max. supply voltage: 27V DC
  • Current consumption: 160 μA
  • Output voltage (string): 2.00V (single)
  • Output voltage (string): 3.00V (double)
  • Output voltage (strumming): 3.00V (single)
  • Output voltage (strumming): 4.50V (double)
  • Logo colour: copper (not visible on Metalworks)
  • 2 TW microphone cables (40.6 cm and 27.9 cm)
  • 4 connection cables (14 cm)
  • 1 output cable (15 cm)
  • 1 battery cable (18 cm)
  • 2 push-pull potentiometers (25K)
  • 2 25K tones
  • 1 stereo output jack
  • 1 input/output bus for 2 microphones
  • 1 battery bus
  • 2 pairs of fixing screws and springs
  • Mic dimensions: 78.5 x 38.1 x 27.6 mm
  • Thickness: 1.1" (27.9 mm)
  • Weight (each microphone): approx. 120 g
The EMG 57/66 TW Axe Long Black pick-up set offers a rare silence. Its noise floor is almost imperceptible. It's much lower than other active microphones. You'll pick up every nuance without interference.

In single-coil mode, the dynamics demand a more precise touch. Every attack comes through cleanly, with lively transients that bring the playing to life.

The solderless installation is reassuring. Even on tour, the connections can withstand travel. The invisible copper logo completes the discreet look. You lose the visible branding, but gain stealthy elegance.
EMG - 57/66 TW Set Long Shaft Black
EMG - 57/66 TW Set Long Shaft Black
204,17 € excl VAT
including eco-part : 0,07 €
Out of stock
Contact us for delivery times
Guarantee 3  years
Fred
Fred
Eric
Eric
Do you need help?

Spotlight on